• Your shopping cart is empty!



Our Classic Fuel Injection systems are E10 fuel compatible

  • TRE 60lb Bosch/Siemens Deka IV Style Fuel Injectors - 630 cc/min

We source these injectors from TRE in California.
They specialise in building and modifying injectors in their USA workshops.

All injectors supplied by them are flow tested on their ANSU flow rig before dispatch allowing us to sell the injectors in flow matched sets

These 630cc injectors are an ideal replacement to the generally unobtainable Siemens Deka 630cc
( The Deka's are reported to be back in production by Continental but they are expensive and can be hard to find stock ) 


Currently 2 in stock but a further 100 in build / transit and should arrive next few weeks 



Select quantity of injectors required to receive discounts for higher quantities



Specifications
Typical Flow Rate in LB per hour: 60 LBS/HR @ 45 PSI
Typical Flow Rate in CC per minute: 630 CC/min @ 45 PSI
Actual flow rate of your injectors may vary, but will be matched together
Resistance: 10 ohms (High Impedance, High Resistance)
Voltage: 8-15 Volts, nominal 13.5 Volts
Amperage: 1.0 Amps
Pressure: Min 30 PSIG / Max 100 PSIG
O-Rings Included: Yes, on the injectors
Injector Body Design: Metal and composite plastic
Fuel Delivery: Upgraded single fuel delivery nozzle for superior fuel atomization
Electrical connector type: EV1 (Minitimer, Jetronic)
Overall Length: 2 7/8 inches, 74 mm
O-ring to O-ring Length: 2 1/2 inches, 63 mm
Diameter: 16 mm
Orings: Top and bottom, 14.5 mm



Nominal flow of these injectors is 630cc but actual flow may vary during flow tests

Where ever possbile we will supply in sets with the closest flow match to each other

Typically most injectors are in the range of 625 to 635cc but we do see some as low as 590c or some as high as 650cc

If you do particularly wish for lower or higher flow range parts please advise at time of order and we will supply accordingly if possible





TRE 60lb Bosch/Siemens Deka IV Style Fuel Injectors - 630 cc/min

  • £60.00

  • Ex Tax: £60.00

Available Options


Tags: TRE 60lb Bosch/Siemens Deka IV Style Fuel Injectors - 630 cc/min




IMPORTANT INFORMATION RELATING TO OUR COMPLETE FUEL INJECTION VEHICLE KITS

These kits are only suitable for vehicles with a Negative Earth electrical system.
If your vehicle is the older Positive Earth then you must convert the vehicle to Negative Earth before fitment.
Many older vehicles have already been converted but if you need to convert this is normally a simple process often cost free.


The full vehicle kits will normally be supplied with the ECU pre loaded with an initial start file.

This initial start file is simply provided as an aid for engine starting, it should not be considered a suitable final calibration for your engine.
You must be prepared to undertake further ECU calibration work to ensure the ECU files are tailored to your vehicle.
Failure to successfully complete the calibration process may lead to poor vehicle driveability or even damage to your engine.

Our Classic Fuel Injection Kits are custom built to order and to the customer general specification and as such are exempt from automatic return rights under Consumer Contract regulations.
By ordering this conversion kit you understand that further ECU calibration work will be required and the final results are outside of our control.
We cannot accept returns or claims arising from failure to successfully complete the calibration process.